At last we are ready to assemble the glass screen waterfeature!
The clamps have now been re-fabricated with the new angle to accommodate the curve of the glass. They are bolted onto the floor of the sump ready to receive the glass screen (with pvc protection between)
Yes !!! it works !!
The glass is now in place and the task of delivering the correct flow of water to the top edge is begun.
We offered the waterblade to the top for a trial run and and found the effect really good. Now all we have to do is drill through the stainless steel sheet and the concrete block wall and connect up to the pump in the sump.
We offered the waterblade to the top for a trial run and and found the effect really good. Now all we have to do is drill through the stainless steel sheet and the concrete block wall and connect up to the pump in the sump.
Tomorrow we will install the lighting (led and low voltage uplight). Can't wait ! Just wish it would stop raining!
0 comments:
Subscribe to:
Post Comments (Atom)
Posts
